librarygogl.blogg.se - Zune firmware 64

#Zune firmware 64 install
#Zune firmware 64 update
#Zune firmware 64 Pc
#Zune firmware 64 download

#Zune firmware 64 update

Once the files are chosen the update will begin.

The new firmware can be found where you saved it before beginning.

Select your RP Interface from the "Interface select" pull down menu.

If unsuccessful, reconnect PAC-UP to the computer and restart the software. The "Connected" check box will be checked if successful.

Click "Connect" button to establish connection between the PAC-UP and the computer.

Open the Interface Updater Program by going to Start >All Programs >AAMP of America > Interface Updater.

Connect the PAC-UP to the computer using supplied USB cable.

The "Interface Updater" will update the files from the computer to RP Interface.

#Zune firmware 64 install

This will install "Interface Updater" onto the computer.

If this is the first time, run and install "Interface Updater Setup".

Not doing so may damage the interfaces software. It is VERY important that you use the latest version of Interface Updater.

#Zune firmware 64 download

If not updated, download and install the latest version of the PAC-UP firmware. Connect the BCI-FD21 module to the vehicle harness, and verify proper operation.Reset the DIP switches to the appropriate configuration for your installation.Remove the BCI-FD21 module from the vehicle harness.When the LED stops flashing, the update process is complete.While the module is updating the firmware from the USB port, the LED will flash purple.ĭO NOT REMOVE THE USB DRIVE UNTIL THIS LED STOPS FLASHING.Connect the BCI-FD21 module to the vehicle harness.Insert the thumb drive with firmware file into the module’s USB port.

Set the DIP switches according the diagram below.

Disconnect the BCI-FD21 module from the vehicle harness.

The DIP switches will need to be returned to this configuration after the firmware update is complete.

Note the current DIP switch configuration.

FT_RCFM(1).faa) will prevent the successful update of the module.

Note: The file name must remain exactly FT_RCFM.faa Any additional characters (i.e.

Load the firmware file (FT_RCFM.faa) onto the root of a thumb drive.

RIGHT-CLICK and select "Save link as.".

Download the latest version of firmware.

#Zune firmware 64 Pc

Use a PC to format a USB thumb drive using FAT32 file system (default setting).Through the steps outlined below, you can update the firmware on the module to the most current revision Pre-Update Preparation This process requires a thumb drive, formatted to FAT32, a specific firmware file, and access to the BCI-FD21 module.

Connect the interface to the computer using a standard to micro USB.Open the AmpPROPC Application using the new shortcut created on your desktop.The AmpPRO program will then install the update files from the computer to the interface. This will install the PC Application onto the computer. If this is the first time using the AmpPROPC Application, run and install “ampproexe”.Connect the interface to the computer's USB port and install the update.It is VERY important that you use the latest version. Download the latest version of the AmpPRO PC Application.When successful it will show the text "Update Completed". Once the file is chosen the update will begin.Click “Select File” and browse to the new firmware file.Connect the interface to the computer using a standard to micro USB cable.Open the AmpPRO PC Application using the new shortcut created on your desktop.The AmpPRO program will then install the update files from the computer to the interface. If this is the first time using the AmpPRO PC Application, run and install “amppro_setup.exe”.Connect the interface to the computer's USB port and install the update.Extract the firmware file and setup file from the.Download the latest version of our firmware.Download the latest version of the AmpPRO PC Application.